SimTech WeldTech Manual de usuario descargar pdf (Pagina 9)

WeldTech - 75 Instruction Manual

SIMTECH

Phone: 877-777-2467 • Fax: 215-547-9129

www.SimtechUSA.com

1.070714

2.8 Maintenance, Inspection and Repair

All maintenance and repair works have to be basically performed with the machine

in off position. During this the machine has to be secured against unintentional

switching on.

Prescribed maintenance and inspection works should be performed in time. The

DVS gives the advice of inspection works after 1 year.

For machines with a specially high usage percentage the testing cycle should be

shortened.

The works should be performed at SIMTECH or by an authorized partner.

2.9 Dangers caused by Electric Energy

Only skilled persons are allowed to work at electrical appliances.

• The electrical equipment of the machine has to be checked regularly. Loose

connections and damaged cables have to be replaced immediately

• If works at alive parts are necessary, a second person has to be present who can

disconnect the machine in emergency cases.

• The heating element is to be protected from rain and dropping water. If need be

use a welding tent.

• According to VDE 0100, the use on construction sites is only allowed with a

power distributor with a FI-safety switch.

2.9.1 Danger of being burnt by Heating Element and Welding Area

You can burn parts of your body and inﬂammable materials can also be ignited !

The heating element is heated up to more than 260°C !

• Do not touch the surfaces of the heating element.

• Do not leave the heating element unsupervised.

• Take enough safety distance to inammable materials.

• Do wear safety gloves.

2.9.2 Danger of Sugeezing by Guideways

There is a danger of serious injuries: on the one hand between the inner clamping

devices and on the other hand between the outer clamping device and the end of

the guideway.

• Do not put hands between clamped pipe ends.

• Do not touch the guideways.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

Sin comentarios

SimTech WeldTech Manual de usuario Pagina 9